uk es it fr pt nl
Escollera Sur (Mar del Plata) ratings
Quality on a good day: 3.0
Consistency of Surf: 3.0
Difficulty Level: 3.5
Wind and Kite Surfing: 4.0
Crowds: 3.0

Overall: 3.5

See all 18 ratings

Based on 2 votes. Vote


Surf Report Feed

Escollera Sur (Mar del Plata) Swell Statistics, June: All Swell – Any Wind

This chart shows the combination of swells directed at Escollera Sur (Mar del Plata) through a typical June, based on 2306 NWW3 model predictions since 2006 (values every 3 hours). The wave model does not forecast wind and surf right at the shore so we have chosen the optimum grid node based on what we know about Escollera Sur (Mar del Plata). In this particular case the best grid node is 5 km away (3 miles).

The rose diagram illustrates the distribution of swell directions and swell sizes, while the graph at the bottom shows the same thing but without direction information. Five colours illustrate increasing wave sizes. Blue shows the smallest swells, less that 0.5m (1.5 feet) high. These happened only 33% of the time. Green and yellow illustrate increasing swell sizes and red shows biggest swells greater than >3m (>10ft). In each graph, the area of any colour is proportional to how commonly that size swell occurs.

The diagram implies that the most common swell direction, shown by the largest spokes, was SE, whereas the the prevailing wind blows from the WNW. Because the wave model grid is out to sea, sometimes a strong offshore wind blows largest waves away from Escollera Sur (Mar del Plata) and offshore. We lump these in with the no surf category of the bar chart. To keep it simple we don't show these in the rose diagram. Because wind determines whether or not waves are good for surfing at Escollera Sur (Mar del Plata), you can view an alternative image that shows only the swells that were forecast to coincide with glassy or offshore wind conditions. Over an average June, swells large enough to cause clean enough to surf waves at Escollera Sur (Mar del Plata) run for about 67% of the time.

IMPORTANT: Beta version feature! Swell heights are open water values from NWW3. There is no attempt to model near-shore effects. Coastal wave heights will generally be less, especially if the break does not have unobstructed exposure to the open ocean.